For optimum operability,
the safe can be positioned on a VdS-approved steel base at. The base height can be selected from 65 mm to 800 mm.

Models with EMA connection preparation can be ordered
with a switch set. VdS-approved
alarm detectors and junction boxes (top side of safe door
and inside of safe ceiling) enable correct
monitoring of the door position and locking status.
The switch set is installed by Wertheim, the
connection and fine adjustment are carried out on site.

Note: If a drawer/pull-out shelf is installed in the top position, a switch set is not possible for grade I, II and type CP safes. The connecting cable (door/cabinet) is designed as a hanging loop.

Safes that do not offer certified fire protection,
can be fitted with an optional fire protection door rebate seal
.

The aluminum-look LED light with integrated
motion detector is battery-operated and
rechargeable via micro USB. It is magnetic
and can therefore be placed anywhere in the safe.

Dimensions: 100 x 70 x 10.6 mm

If further drill holes are required in addition to the prepared floor, rear wall or cable drill holes, these can be taken into account after notification of the position (side wall, rear wall, ceiling, floor) and technical inspection.

NOTE: When positioning special drill holes (especially in the side panel), please note possible interior fittings. As standard, 1 pc. Anchoring material is included in the scope of delivery. If additional anchors are required, this must be specified when ordering.